Use the flat end of a spudger to pry the optical drive connector up from its socket on the logic board. Use the flat end of a spudger to pry the AirPort/Bluetooth connector up from its socket on the logic board. Pull the cable parallel to the face of the logic board. о‚ Do not lift up on the cable as you disconnect it from the logic board. оЃ It is useful to pry upward on both short sides of the connector to 'walk' it out of its socket.Д«end the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.Дisconnect the camera cable connector from its socket on the logic board. Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board. If you do not disconnect the battery connector, please be careful as parts of the motherboard might be electrified. hard drive), disconnecting the battery connector is not necessary but it prevents any accidental shorting of electronics on the motherboard. Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

Remove the following ten screws securing the lower case to the upper case: п„‘ MacBook Pro 15' Unibody (Mid 2009/Mid 2010/Early 2011/Late 2011) SATA SuperDrive Cable (1) INTRODUCTION Use this guide to replace the short optical drive ribbon cable connecting the optical drive to the logic board.

MacBook Pro 15' Unibody Late 2011 Optical Drive Cable Replacement Replace a damaged optical drive cable on your Late 2011 MacBook Pro 15' Unibody. MacBook Pro 15' Unibody Late 2011 Optical Drive Cable Replacement

Macbook pro 2011 used optical drive